Auction bucket re lug. The customer got a good deal on this bucket at the auction, but their machine has a very oddball quick change. I templated another one of his buckets, measured the quick change and templated the new bucket so I could work it all together. A little CardboardAD and ComputerAD and Pacific Bending in 100 Mile was able to cut me some nice clean lug profiles. Do you need some Heavy Equipment repairs done by a mobile welder? Or a custom project fabricated? We

This thumb had seen better days for sure. Fabricated some new tips / extensions and fit them on. The left side was especially worn so the new pieces ended up being asymmetrical to try and make up for the difference, the tips were within an ⅛ in every measurable dimension which is what matters. Do you need some Heavy Equipment repairs done by a mobile welder? Or a custom project fabricated? We are located in the Cariboo east of 100 Mile House and willing to take our mobile ser

I've been picking away at this for a bit and finally wrapped it up today. The bucket that came on the tractor served the purpose of clearing snow this winter, but it needed some help. I had a fair bit of time in this but minimal material expense, everything was leftover or crops laying around. The base edge got replaced and and I added a second replacement cutting edge. The base edge consists of 2 crops of ½ ar 400 that I spliced and started out warped. A bit of clamping and

A short notice bucket rehab. The customer wanted to replace the tooth adapters and convert them to a more common style. We replaced a section of the cheek plates and did some work on the heel edge while I was there. Do you need some Heavy Equipment repairs done by a mobile welder? Or a custom project fabricated? We are located in the Cariboo east of 100 Mile House and willing to take our mobile service truck off the beaten path to get the job done. Contact us today at mike@bu

Tight timelines and tight budgets, again. "Cold formed" the floor to make timelines and save some money, otherwise a fairly standard...

Wrapped up a big one today. Complete overhaul on the front end of this 870 bucket. Fixed numerous cracks in the frog, built up worn...

Cutting up scraps, crops and used cutting edges to make this bucket as good as possible. A bit more time put in but the customer has all...

New edge and heel straps to keep this bucket going for a good while longer. Owner had had bad luck with bolt on edges not lasting a...

Another bucket re lug. Originally we wanted to take the good lugs off the trashed bucket and re use them, they looked really close but...

Welder or dentist? Another tooth adaptor repair to keep things going. Not the first and probably not the last on this poor old bucket,...

A ton of build up with with a healthy covering of hard surfacing for this thumb. The heat cycling exposed a few cracks so I fixed those...

A bunch of build up and hard surfacing as preventive maintenance on this bucket. Personally I prefer wear plates over hard surface as I...

Fun from the last couple weeks, new processor knives and some bucket build up and hard surfacing. I love the smell working on forestry...

Another bucket rehab complete, this time on a skid steer. Stripped it right down to almost nothing and replaced most of the floor, back...

Another bucket fixed up and ready for more work. New frog, floor replacement, bottom side armor and upgrade to a bolt on edge. This...

Nice bucket rebuild with a conversion to a bolt on cutting edge. Bucket is almost as good or better than new and ready for many more...

A recent service call up to the Kookipi for some roadbuilder repairs, fixed some cracks in a couple buckets and a quick change. The...